Insulators to meet and be listed with IPC/IAPMO Property and Material Standard PS 94-2012. With a one-piece design, fusion molded fabrication and pliable for high flexibility requirements. PVC insulator to be 1/8 in thick and shall meet Testing Standard ASTM E 84-07 with a 25 flame spread/ 450 smoke index per IBC Chapter 8. Surfaces to be soft, smooth, non-absorbent, easy to clean U/V inhibited, antimicrobial, antifungal properties. Insulators shall have a dual fastening system which consists of fusion bonded Velcro fastener strips for full slit enclosure and tamper resistant, smooth, non-abrasive snap-locking fasteners. Surfaces to be soft, smooth, non-absorbent, easy to clean U/V inhibited, antimicrobial, antifungal properties. Insulators shall have a dual fastening system which consists of fusion bonded Velcro fastener strips for full slit enclosure and tamper resistant, smooth, non-abrasive snap-locking fasteners. P-Trap Insulator: Universal fit for 1-1/4 to 1-1/2 in brass or plastic traps and shall have drainage at lowest point to prevent condensation and or leakage build up. Valve and Supply Insulator: Universal fit over valve handles and for brass, plastic or metal braided supplies or connectors and shall be able to flex-curl to a minimum of 360 degrees for full slit closure for total compliance. Off-Set Insulator: Sized and designed to fit inside of P-trap insulator for custom fit.